Hitachi 885426 Replacement Part for Auto Unloading Valve Ec2510E
- Replaces Hitachi 885426 for EC2510E Gas Compressors 110 – 140 PSI
- 1/2″ Metric Flare TOP Inlet x 3/8″ Male Pipe Thread outlet to air tank
- For use on Hitachi power tool products
- Hitachi 885426 AUTO UNLOADING VALVE EC2510E Replacement Part
Replaces Hitachi 885426 for EC2510E Gas Compressors 110 – 140 PSI Made in USA Check valve /Unloader valve / Pilot valve all in one – (continuous run unloader) for gas & electric powered air compressors 110 – 140 PSI factory setting. pressure can be adjusted 30-40 psi up or down 1/2″ Metric Flare TOP Inlet x 3/8″ Male Pipe Thread outlet to air tank ( Visit our store for a wide variety of HP ratings and Multiple Inlet / Outlet configurations ) Pressure can be adjusted 30-40 PSI Higher or Lower. If pressure adjustment is needed, Please see Pic attachment for adjustment instructions. 30 scfm Rating – comes complete with hand unloader and muffler/silencer – Inlet / Outlet are in-line with each other Piloted discharge check valves combine a pilot valve, a discharge valve, and a check valve into one system used to run an air compressor at a constant speed. They are used on both gas engine and electric motor compressors. The top inlet portion of the valve will connect to your main airline from your pump. The bottom outlet will connect to your air receiver tank. The 1/8″ Male NPT Connection on the Throttle control cable will connect to the throttle control port on the unloader. The Z bend tip of the throttle control cable will connect to the throttle arm on your engine. Muffler is included to reduce noise. Please Contact us if you have any questions
List Price: $ 59.99
